Panasonic NV-SD350 - Page 46

(46)
“EMT indication Erasure prevention tab on Use tape with intact erasure prevention tab, or cover
flashes whenever cassette is broken off. tab hole with adhesive tape, if original recording is
recording is no longer required.
attempted.
Picture is recorded Aerial or aerial lead is Check aerial connection to VCR. See page 8.
; with noise or blank | defective. Check your norma! TV picture. if there is no picture, |
| screen. | | check your aerial. |
| VCR is not correctly tuned. Re-tune VCR. See pages 34-35. |
I I
Ai, A2 or A3 is selected. Select the required TV programme. |
Timer recording Clock or calendar is Check clock and calendar. Set to present time.
cannot be incorrectly set. 1 (Note this is a 24 hour clock.) See page 39. i
performed. {
: Recording start or end time Set recording start and end time correctly. i
: setting is incorrect. i
| VCR is not set for timer
Press TIMER REC after programming for timer
recording.
ere feel ma 1 Mie recording.
| AV external | Ai, A2 or A3 is not selected.
i recordingscannot +
: be made. ! External AV connections are Check that connections for externa! video and audio
| incorrect. source are correct. See page 27.
Select At, A2 or A3 by pressing INPUT SELECT.
ap fe an Ae re
Remote controller Remote controller transmitter Ensure that remote controller is being pointed at
; does not operate beam is not reaching VCR. VCR and that transmitter beam is not obstructed. i
! correctly. :
| Distance is too far. Use remote controller within 7 m of VCR. !f this i
range is not possible, replace batteries. : i
| Batteries are exhausted. Replace batteries. Note precaution for replacement; |
on page 13. | |
Batteries are incorrectly fitted Fit batteries correctly as shown on page 13.
with (+/—) reversed.
Wrong remote control mode
Set to the correct ramote control mode. j i
| has been selected.
See page 13.