－ 17 －
5.STARTUP AND TERMINATION
Connection
Connection of cable (DV0P1960) for RS-232C
Make sure that power has been disconnected from the amplifier and
personal computer. Surely insert the cable plug on the miniDIN side
to the connector (EX. MINAS-A:CN SER) of the amplifier, and insert
the plug on the 9- side to the RS-232C connector COM1 port of the
personal computer.
For MINAS-A4,AⅢ,A series amplifier, set ID (RSW) to any of 1 to F.
For connection, please read the instruction manual of the amplifier.
Amplifier
SER
DV0P1960
Personal computer
PANATERM
cable
※The name of the connector is a MINAS-A series.
Connection of cable(DV0P197□) for RS-485(MINAS-A4,A3,A series)
To connect several amplifiers, connect the connector of each
amplifier as shown below. Set the ID (RSW) of the amplifier
connected with the personal computer to 0, and set the other
amplifier IDs (RSWs) to 1 to F, taking care not to duplicate
an ID.
Amplifiers (Series MINAS-A4,AⅢ,A)
ID（RSW）
NET NET NET NET
SER SER SER SER
012 F
Up to 16 units
DV0P1960
DV0P197□ cable
Personal computer
PANATERM
※The name of the connector is a MINAS-A series.
To Next Page
Loading...
