Panasonic PANATERM Ver. 3.7 - Troubleshooting; Setup and Startup Issues

－ 70 －
6.OPERATION
Communication setting
You can set the condition for communication between PANATERM
®
and the amplifier. Note that the conditions are effective only
on the personal computer and are not introduced to the amplifier.
■Notes:
・Usuall
y,
use PANATERM
®
with the initial settin
g
.
Communication set-up
1 Click “File” on the PANATERM
®
menu bar, and click “Setting” and
“Communication set-up”.
2 The communication window will
appear. Click the input area of the item to be set.
3 Input or select the setting.
4 To enable the setting, click “OK”.
<RS232C setting>
MINAS-A4 series cannot use this setting.
“RS232C port”: Select a communication port to be used from
COM1 to COM16.
“Communication speed”: Select communication speed in the range
from 2400 bps to 9600 bps.
■Notes:
・ ・When the communication speed has been changed, communication cannot be
・ established
unless the communication speed on the amplifier is set to the same value.
<Protocol setting>
“Time-out period T1”: Specify the time-out time T1 between
characters in 0.1second units.
“Time-out period T2”: Specify the time-out time T2 between
protocols in second.
“Retry times”: Specify the number of communication
retries. The setting range is 1 to 8.