－ 71 －
7.TROUBLHSOOTING
Failure in setup
The setup sequence is suspended.
→ After restarting Windows
®
, restart the setup program.
→ Clean the CD-ROM drive.
→ Ensure that the hard disk in which PANATERM
®
will be installed
has enough vacant capacity.
(The recommended capacity is 15MB.)
→ Copy all the files of the PANATERM
®
setup CD-ROM into the same
folder on the hard disk. Then, start installation using a setup
program “setup.exe ” or “setupXP.exe” in the folder.
Although PANATERM
®
was installed, it has not been registered in the
start menu/program.
→ After the setup sequence is finished, restart Windows
®
.
You can not start installing with “It has been already installed.”
displayed.
→ Use “Start” “Control panel” “Add and eliminate program” and
uninstall PANATERM
®
to start setup program again.
PANATERM
®
does not start.
“PANATERM
®
has started already.” is displayed, and it does not start.
→ PANATERM
®
has started already. Select PANATERM
®
on the task bar.
→ The PANATERM
®
file has been destroyed. Uninstall PANATERM
®
using
the “Add application” and “Delete application” function on the
control panel in the “Set” item in the “Start” menu, and set up
PANATERM
®
again. (Saved parameter files may be lost. Make backup
copies of the files in advance.)
To Next Page
Loading...
