－ 12 －
3.SETUP
Install PANATERM
®
on the hard disk of the personal computer
using setup CD-ROM. PANATERM
®
cannot be installed on the
network drive. It cannot be installed or setup by any other
means, such as the copy function. It cannot be started from a
CD-ROM.
1 Turn on the power to the personal computer, and start
Windows
®
(If any software has been started, terminate it.)
2 Insert the PANATERM
®
setup CD-ROM into the CD-ROM drive.
If the autorun program starts at this time, execute
operation according to the guidance, and move on to 5.
3 Start Explorer (for Explorer starting procedure, see the
manual for Windows
®
), and switch to the CD-ROM drive.
4 Double-click the setup program on the CD-ROM.
Japanese version setup is in “Japanese” directory. English
version setup is in “English” directory.
Execute setup.exe on Windows
®
98,Me, 2000, and SetupXP.exe
on Windows
®
XP.
(If the “Add application” menu on the control panel is used,
the software may not be installed normally.)
In the middle of the procedure, you will be asked to replace
the setup disk. It is not failure, so keep pushing OK button
until the following screen is displayed.
5 The PANATERM
®
setup program will start.
To Next Page
Loading...
