－ 72 －
7.TROUBLHSOOTING
Failure in communication
When automatic setting or one of COM1 to COM16 is selected on the
model selection screen after PANATERM
®
is started, PANATERM
®
does not
give any response.
When the model selection screen or one of COM1 to COM16 is selected
after PANATERM
®
is started, the “Amplifier or communication port
cannot be detected.” message is displayed, and communication cannot
be made.
→ The amplifier software of the COM port has not been set
properly.
(Select “Set” in the “Start” menu, click “Control panel”, “System”
and “Device manager”, and open “Port”. Make sure that the port to
be used has been set properly. For details, see the instruction
manual for personal computer.)
→ The COM port of the personal computer is used by another device,
such as the built-in modem. (See the instruction manual for
personal computer.)
→ Apply power to the amplifier.
→ Check that the communication cable is not loose, the cable is
not.
Failure printing
Printing cannot be performed.
→ Make sure that the printer is connected correctly.
Print is incorrect. Lines are broken.
→ Change the printer setting. (Select “Printer property”,
“Details”, “Printer setting” and “Device option”, and change the
print quality from “Draft” to “Formal”.)
* See “Printer setting” at the back of this document.
To Next Page
Loading...
