Panasonic PT-AE7000U PT-AT5000E PT-AE700EA PT-AE7000EH

1. 3. Model Information Setup
1. 3. 1. Required equipments
1. PC : Use it as adjustment use.
2. Communication cable : D-sub 9pin (male/emale RS-232C straight)
3. Software : ［Service ORCA10.exe］Adjustment software is downloaded from the projector service homepage.
1. 3. 2. Preparation
1. 3. 3. Setting method
1. Switch the projector to "Standby" mode (POWER indicator is Lighting in red).
2. Start up service software ［Service ORCA10.exe］ with a computer.
3. Select language and click the [ OK ] button.
4. 1) Select the Serial Port of the computer.
2) Select a model number.
(Case of AT5000, select the AE7000.)
3) Click the [ Adjustment ] button.
5. Click the [ Model Info Setup ] button.
6. Put a checkmark in an applicable model, and click the [OK] button.
1. Connect the RS-232C termanal of projector
and PC with a RS-232C cable.
③
①
②
Compute
r
Projecto
r
RS-232C cable (Streight)
ADJ - 4