Panasonic PT-AE7000U PT-AT5000E PT-AE700EA PT-AE7000EH

2. Microprocessor update procedure
* The update is done by SERIAL terminal connection.
* During update, prevent PC from going into stand-by or shut down.
2. 1. Update by the SERIAL terminal connection
2. 1. 1. Equipment to be used
1. Computer : Use it for the transfer of update data.
2. Communication cable : D-sub 9pin (male/female RS-232C straight)
3. Service Software : [PgSendORCA10.exe] Service software is downloaded from the projector service homepage.
4. Microprocessor Software: Please download the file from the projector service homepage to the PC.
2. 1. 2. Preparation
2. 1. 3. Update procedure
1. Switch the projector to "Standby" mode (POWER indicator is Lighting in red).
2. Start up service software [ PgSendORCA10.exe ] with a computer.
3. Select language and click the [ OK ] button.
4. 1) Select the Serial Port of the computer.
2) Select a model number.
(Case of AT5000, select the AE7000.)
3) Select a microcomputer to update.
4) Click the [ PROGRAM LOAD ] button.
5. Appoint the microcomputer software that took in a computer beforehand, and click the [ Open ] button.
1. Connect the RS-232C termanal of projector
and PC with a RS-232C cable.
①
②
③
④
Compute
r
Projecto
r
RS-232C cable (Streight)
ADJ - 7