2. 9. Removal of K1-P.C.board / K2-P.C.Board
1. Remove the A-P.C.Board earth metal according to the steps 1 through 5 in the section
2.4. "Removal of Optical Block / Analysis Block".
2. Unscrew the 4 screws and remove the Optical Block and Analysis Block.
3. Unscrew the 3 screws and remove the Lamp house.
4. Unscrew the 2 screws and remove the Lamp duct base.
5. Unscrew the 2 screws and remove the K-P.C.Board block.
Optical Block + Analysis Block
Lamp house
Lamp duct base
K-P.C.Board block
K1-P.C.Board
K2-P.C.Board
DIS-9
To Next Page
Loading...
