4.3. Functions in Serviceman Mode
This projector has functions such as image cutoff and deletion of registered signals by one operation.
[VIDEO menu]
SDI COLOR SELECT
Sets the using mode of the color-difference information in ET-MD95SD2 480P dual link ("MAIN" only or both "MAIN" and
"SUB").
AD LPF
Sets the low pass filter.
[ADVANCED menu]
PLL Setting
Sets VCO and the charge pump.
Frame Lock
Sets the frame lock.
V Mask
Sets the V mask.
[EXTRA OPTION menu]
Cut off
Sets the display on or off for each color (red, green, and blue).
Deletion of Input Signals
Deletes all the registered signals.
REMOTE 2 Setting
Sets the functions of the REMOTE 2 terminal.
·
When using the contact control and an optional signal selector in combination, set the pins "No. 3, 4, 5, 6, and 7" of the
REMOTE 2 terminal to OPEN. (When REMOTE 2 Setting is "2", set the pins "No. 3, 4, 5, 6, 7, and 8" of the REMOTE
2terminal to OPEN.)
·
When AUX is ET-MD95VM2, the LINE and Y/C selection is set to the last selected condition.
Gamma Selection
Sets the selectable modes of gamma on the VIDEO menu.
STANDARD: You can select the following 5 modes.
"2.2", "2.5", "DEFAULT", "USER 1" and "USER 2"
ALL: You can select the following 13 modes.
"1.0", "1.8", "2.0", "2.2", "2.3", "2.4", "2.5", "2.7", "DEFAULT", "USER 1", "USER 2", "USER 3" and "USER 4"
Fan Full Mode
OFF: Controls the fan speed according to temperature and lamp modes.
ON: Sets the intake fan to the full speed to cool best the power supply and DMD prism, but increases fan noise. At this time,
you cannot select "FAN CONTROL" on the OPTION menu.
Caution:
This mode is for a special usage, usually use it in OFF condition.
10
PT-D7700U / PT-D7700E
To Next Page
Loading...
