Panasonic PT-RQ32K

Chapter 4 Settings — [DISPLAY OPTION] menu
ENGLISH - 113
3) Press as to select [SIGNAL LEVEL ADJUST].
4) Press qw to switch the item.
[OFF] Does not perform automatic adjustment.
[ON]
Adjusts black level (the [PICTURE] menu → [BRIGHTNESS]) and white level (the [PICTURE] menu
→ [CONTRAST]) when automatic setup is executed.
Note
f [SIGNAL LEVEL ADJUST] may not function properly unless a still image containing clear blacks and whites is input.
[BACKUP INPUT SETTING]
Set the backup function that switches the signal to the backup input signal as seamless as possible when input
signal is disrupted.
1) Press as to select [BACKUP INPUT SETTING].
2) Press the <ENTER> button.
f The [BACKUP INPUT SETTING] screen is displayed.
3) Press as to select [BACKUP INPUT MODE].
4) Press the <ENTER> button.
f The [BACKUP INPUT MODE] screen is displayed.
5) Press as to select the combination of the input and press the <ENTER> button.
Primary input Secondary input
Number of signals
constructing one
screen
Details
[OFF] ― Disables the backup function.
[SDI1] [SDI2]
1
Enables the backup function.
[HDMI1 [SLOT1]]
*1
[HDMI2 [SLOT1]]
*1
[HDMI3 [SLOT2]]
*2
[HDMI4 [SLOT2]]
*2
[DVI-D1 [SLOT1]]
*1
[DVI-D2 [SLOT1]]
*1
[DVI-D3 [SLOT2]]
*2
[DVI-D4 [SLOT2]]
*2
[SDI1 [SLOT1]]
*1
[SDI2 [SLOT1]]
*1
[SDI3 [SLOT2]]
*2
[SDI4 [SLOT2]]
*2
[SDI1-2] [SDI3-4]
2
[HDMI1-2 [SLOT1]]
*3
[HDMI3-4 [SLOT2]]
*3
[DVI-D1-2 [SLOT1]]
*3
[DVI-D3-4 [SLOT2]]
*3
[SDI1-2 [SLOT1]]
*3
[SDI3-4 [SLOT2]]
*3
[SDI1-2-3-4]
*3
[SDI1-2-3-4 [SLOT1/2]]
*3
4
*1 This is displayed when the optional Interface Board equipped with corresponding input is installed in <SLOT 1>.
*2 This is displayed when the optional Interface Board equipped with corresponding input is installed in <SLOT 2>.
*3 This is displayed when the optional Interface Boards equipped with corresponding input are installed in <SLOT 1> and <SLOT 2>.
6) Press the <MENU> button.
f The [BACKUP INPUT SETTING] screen is displayed.
7) Press as to select [AUTOMATIC SWITCHING].
f When [BACKUP INPUT MODE] is set to [OFF], [AUTOMATIC SWITCHING] cannot be selected.
8) Press qw to switch the item.
f The items will switch each time you press the button.
[ENABLE]
Switches to the secondary input (primary input) automatically when the input signal for primary input
(secondary input) is disrupted.
[DISABLE] Disables the automatic input switching function.
Note
f The backup function is enabled when [BACKUP INPUT MODE] is set to anything other than [OFF] and same signal is input to the primary
input and the secondary input.