Panasonic PT-RQ32K

Chapter 7 Appendix — Attaching the Long Life Filter Unit (optional)
266 - ENGLISH
Attaching the long life lter cover
Attach the long life lter cover with the air lters to the long life lter mount clasp on the projector body.
Fig. 2Fig. 1
Long life filter cover fixing screws
1) Attach the long life filter cover to the long life filter mount clasp. (Fig. 1)
f Attach the long life lter cover (with the two air lter units attached) to the long life lter mount clasp on the
projector body.
f The long life lter has no difference between top and bottom.
2) Secure the long life filter cover. (Fig. 2)
f Securely x with the two long life lter cover xing screws (knurled head screws) supplied with the Long Life
Filter Unit (optional).
f When the long life lter cover is secured, proceed to “Setting the lter” (x page 266) next.
Setting the lter
Set the type of lter, and then reset the lter runtime (counter numerical value).
1) Turn on the power of the projector.
2) Press the <MENU> button on the remote control or control panel.
f The [MAIN MENU] screen is displayed.
3) Press as to select [PROJECTOR SETUP].
4) Press the <ENTER> button.
f The [PROJECTOR SETUP] screen is displayed.
5) Press as to select [FILTER SETTING].
6) Press the <ENTER> button.
f The [FILTER SETTING] screen is displayed.
7) Press as to select [FILTER TYPE].
8) Press qw to select [LONG LIFE].
9) Press as to select [FILTER COUNTER RESET], and press the <ENTER> button.
10) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
f The [PROJECTOR SETUP] menu → [STATUS] → [FILTER COUNTER] is displayed as “0”.
Attention
f When use of the Long Life Filter Unit is nished and replaced with a standard air lter unit, make sure to reset the lter counter after setting
the [PROJECTOR SETUP] menu → [FILTER SETTING] → [FILTER TYPE] to [NORMAL]. When the [PROJECTOR SETUP] menu →
[FILTER SETTING] → [FILTER COUNTER RESET] is executed, the lter counter is reset.
Note
f Continuing to use the projector with incorrect [FILTER TYPE] setting may cause failure of the projector.
f When the projector is used without resetting the lter counter, the actual lter runtime (counter numeric value) will not be able to be
conrmed.