Panasonic PT-RQ32K

Chapter 4 Settings — [PROJECTOR SETUP] menu
172 - ENGLISH
6) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password of the factory default setting: awsqawsq
f The following settings are not initialized even if [ALL USER DATA] is executed.
g The [DISPLAY OPTION] menu → [UNIFORMITY]
g The [PROJECTOR SETUP] menu → [OPERATION SETTING] → [OPERATING MODE]
g The [PROJECTOR SETUP] menu → [OPERATION SETTING] → [MAX LIGHT OUTPUT LEVEL]
g The [PROJECTOR SETUP] menu → [STANDBY MODE]
g The [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS OPTIMIZER] → [FOCUS OFFSET BRIGHT] and [FOCUS OFFSET
DARK]
g [FILTER TYPE] and [FILTER COUNTER] in the [PROJECTOR SETUP] menu → [FILTER SETTING]
f When a projection lens equipped with EEPROM is attached, following setting will not return to factory default setting even if [ALL USER
DATA] is executed.
g The [PROJECTOR SETUP] menu → [LENS] → [LENS TYPE]
g The [PROJECTOR SETUP] menu → [LENS] → [LENS INFORMATION SETTING] → [LENS ID] and [LENS NAME]
f To initialize the setting values of [FOCUS OFFSET BRIGHT] and [FOCUS OFFSET DARK] in the [PROJECTOR SETUP] menu → [LENS]
→ [ACTIVE FOCUS OPTIMIZER], execute the [PROJECTOR SETUP] menu → [LENS] → [FOCUS OFFSET SETUP] → [INITIALIZE].
f If [ALL USER DATA] is executed, the [INITIAL SETTING] screen is displayed when the projection is started the next time.
[SERVICE PASSWORD]
This function is used by a service person.