Panasonic PT-RQ32K

Chapter 6 Maintenance — Maintenance/replacement
220 - ENGLISH
Resetting the lter counter
1) Turn on the power of the projector.
2) Press the <MENU> button on the remote control or control panel.
f The [MAIN MENU] screen is displayed.
3) Press as to select [PROJECTOR SETUP].
4) Press the <ENTER> button.
f The [PROJECTOR SETUP] screen is displayed.
5) Press as to select [FILTER SETTING].
6) Press the <ENTER> button.
f The [FILTER SETTING] screen is displayed.
7) Press as to select [FILTER COUNTER RESET], and press the <ENTER> button.
8) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
f The [PROJECTOR SETUP] menu → [STATUS] → [FILTER COUNTER] is displayed as “0”.
Note
f When the projector is used without resetting the lter counter, the actual lter runtime (counter numeric value) will not be able to be
conrmed.
Replacing the unit
Filter
If dirt does not come off even after the air lter unit is maintained, it is time for the unit to be replaced.
The Replacement Filter Unit (Model No.: ET-EMF330) is an optional accessory. To purchase the product, consult
your dealer.
Attention
f Make sure to turn off the power before replacing the lter. (x pages 59, 69)
f Make sure that the projector is stable, and perform the maintenance in a safe place even if the lter falls accidentally.
Note
f The replacement cycle of the air lter unit varies greatly depending on the usage environment.
For the air lter unit
The section describes the replacement procedure of the standard air lter unit attached to the projector.
This air lter unit is the same as the Replacement Filter Unit (Model No.: ET-EMF330) (accessory/optional
accessory).
1) Remove the air filter unit.
f Refer to “Removing the air lter unit” (x page 215) of the standard air lter unit.
2) Attach the Replacement Filter Unit (Model No.: ET-EMF330) (accessory/optional accessory) to the
projector.
f Refer to “Attaching the air lter unit” (x page 216) of the standard air lter unit.
3) Reset the filter counter.
f Refer to “Resetting the lter counter” (x page 217) of the standard air lter unit.
Attention
f When switching on the projector, make sure that the air lter unit is attached. If it is not attached, the projector will suck in dirt and dust
causing a malfunction.
f When the projector is used without the air lter unit attached, the lter indicator <FILTER> lights up in red.
f When the projector is used without resetting the lter counter, the actual lter runtime (counter numeric value) will not be able to be
conrmed.