Panasonic PT-RQ32K

Chapter 4 Settings — [DISPLAY OPTION] menu
128 - ENGLISH
Note
f This function does not operate when the SD-SDI signal or the HD-SDI signal is input.
f [3G-SDI MAPPING] cannot be set when [SDI LINK] is set to [AUTO].
Setting [SYSTEM SELECTOR] in [SLOT IN] (SDI input)
1) Press as to select [SLOT IN].
2) Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
3) Press as to select [SINGLE LINK SETTING], [DUAL LINK SETTING], or [QUAD LINK SETTING], and
press the <ENTER> button.
f The [SINGLE LINK SETTING] screen, the [DUAL LINK SETTING] screen, or the [QUAD LINK SETTING]
screen is displayed.
f Proceed to Step 5) when [DUAL LINK SETTING] or [QUAD LINK SETTING] is selected.
4) Press as to select [SDI1], [SDI2], [SDI3], or [SDI4], and press the <ENTER> button.
f The [SINGLE LINK SETTING] screen for the selected item is displayed.
5) Press as to select [SYSTEM SELECTOR].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
Automatically selects [RGB], [YP
B
P
R
4:4:4], or [YP
B
P
R
4:2:2].
[RGB], [YP
B
P
R
4:4:4], or [YP
B
P
R
4:2:2] is automatically selected by reading the payload ID attached to
the input signal. [RGB] is selected when the payload ID is not attached to the input signal.
[RGB] Fixes to [RGB].
[YP
B
P
R
4:4:4] Fixes to [YP
B
P
R
4:4:4].
[YP
B
P
R
4:2:2] Fixes to [YP
B
P
R
4:2:2].
Setting [BIT DEPTH] in [SLOT IN] (SDI input)
1) Press as to select [SLOT IN].
2) Press the <ENTER> button.
f The [SLOT IN] screen is displayed.
3) Press as to select [SINGLE LINK SETTING], [DUAL LINK SETTING], or [QUAD LINK SETTING], and
press the <ENTER> button.
f The [SINGLE LINK SETTING] screen, the [DUAL LINK SETTING] screen, or the [QUAD LINK SETTING]
screen is displayed.
f Proceed to Step 5) when [DUAL LINK SETTING] or [QUAD LINK SETTING] is selected.
4) Press as to select [SDI1], [SDI2], [SDI3], or [SDI4], and press the <ENTER> button.
f The [SINGLE LINK SETTING] screen for the selected item is displayed.
5) Press as to select [BIT DEPTH].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO] Automatically select [12-bit] or [10-bit].
[12-bit] Fixes to [12-bit].
[10-bit] Fixes to [10-bit].
Setting [SIGNAL LEVEL] in [SLOT IN] (SDI input)
1) Press as to select [SLOT IN].