Chapter 4 Settings — [SECURITY] menu
ENGLISH - 181
4) Press the <ENTER> button.
f The [CONTROL PANEL] screen or the [REMOTE CONTROL] screen is displayed.
5) Press as to select [CONTROL PANEL] or [REMOTE CONTROL].
6) Press qw to switch [USER].
7) Press as to select the button item to set.
f When [INPUT SELECT BUTTON] is selected, press the <ENTER> button, and then press as to select
the button to set.
Buttons that can be set
[CONTROL PANEL] [REMOTE CONTROL]
[POWER BUTTON]
Power standby <v> button, power on <b> button
[INPUT SELECT BUTTON]
<SDI 1/2> button, <SDI 3/4> button, <DIGITAL
LINK> button, <SLOT 1> button, <SLOT 2>
button, <INPUT MENU> button
<DVI-D> button, <HDMI> button, <SDI> button,
<DIGITAL LINK> button, <SLOT 1> button,
<SLOT 2> button, <INPUT MENU> button
[MENU BUTTON] <MENU> button
[LENS BUTTON] <LENS> button Lens buttons (<FOCUS>, <ZOOM>, <SHIFT>)
[AUTO SETUP BUTTON] <AUTO SETUP> button
[SHUTTER BUTTON] <SHUTTER> button
[ASPECT BUTTON] ― <ASPECT> button
[ON SCREEN BUTTON] ― <ON SCREEN> button
[OTHER BUTTON]
asqw, <ENTER> button
Buttons not listed above
8) Press qw to switch the item.
[ENABLE] Enables button operations.
[DISABLE] Disables button operations.
f When [INPUT SELECT BUTTON] is selected in Step 7), the item that can be set varies depending on the
selected button.
Refer to “Item that can be set with [INPUT SELECT BUTTON]” (x page 182) for details.
Once the switching of the item is completed, press the <MENU> button to return to the [CONTROL PANEL]
screen or the [REMOTE CONTROL] screen.
9) Press as to select [APPLY], and press the <ENTER> button.
f The conrmation screen is displayed.
10) Press qw to select [OK], and press the <ENTER> button.
Note
f When a button operation is performed on the device set to [DISABLE], the [CONTROL DEVICE PASSWORD] screen is displayed.
Enter the control device password.
f The [CONTROL DEVICE PASSWORD] screen will disappear when there is no operation for approx. 10 seconds.
f If the operations of both [CONTROL PANEL] and [REMOTE CONTROL] are set to [DISABLE], the projector cannot be turned off (cannot
enter standby).
f When the setting has completed, the menu screen will disappear. To operate continuously, press the <MENU> button to display the main
menu.
f Even when you set button operations on the remote control disabled, operations of the <ID SET> and <ID ALL> buttons on the remote
control are kept enabled.
To Next Page
Loading...
