Panasonic PT-RQ32K

Chapter 6 Maintenance — Troubleshooting
ENGLISH - 223
Problems Points to be checked Page
Lens shift cannot be
adjusted.
f Perform [LENS CALIBRATION]. 149
f Is the Fixed-focus Lens (Model No.: ET-D75LE50) attached? ―
Geometric adjustment is
not possible.
f Is [QUAD PIXEL DRIVE] set to [OFF]? 100
f Is [SIMUL INPUT SETTING] set to [AUTO(x2-speed)] or [AUTO(x4-speed)]? 100
Cannot control the
projector with Art-Net.
f Are the connections between the twisted-pair-cable transmitter and an external
device, and between the twisted-pair-cable transmitter and projector correctly done?
―
f Is [Art-Net SETUP] set to other than [OFF]? 186
f Are [NET], [SUB NET], [UNIVERSE], and [START ADDRESS] set correctly? 186
The DIGITAL LINK input
image is not displayed.
f Is the cable compatible to the condition of the projector used? 55
f Are the connections between the twisted-pair-cable transmitter and the projector or
an external device correctly done?
―
f Is [DIGITAL LINK MODE] set to [AUTO] or [DIGITAL LINK]? Is it set to
[ETHERNET]?
184
f Is a signal which is not compatible with a twisted-pair-cable transmitter being input? ―
Cannot switch to the input
of the Interface Board.
f Is the Interface Board correctly installed in the slot? 270
f When the 3G-SDI Terminal Board with Audio is installed, is the rmware version of
the 3G-SDI Terminal Board with Audio (Model No.: TY-TBN03G) 2.00 or later?
33
Attention
f If problems persist even after checking the preceding points, consult your dealer.