Chapter 1 Preparation — About your projector
ENGLISH - 33
Note
f This projector does not support audio output because it is not equipped with audio function. However, when SDI signal with audio is input to
the <3G-SDI 1 IN>/<3G-SDI 2 IN>/<3G-SDI 3 IN>/<3G-SDI 4 IN> terminal, a signal with audio is output from the <3G-SDI 1 OUT>/<3G-SDI
2 OUT>/<3G-SDI 3 OUT>/<3G-SDI 4 OUT> terminal.
f To use the 3G-SDI Terminal Board with Audio (Model No.: TY-TBN03G), it is necessary for the rmware version of the 3G-SDI Terminal
Board with Audio to be 2.00 or later. Conrm the rmware version of the 3G-SDI Terminal Board with Audio when it does not operate after
installing to the projector.
Consult your dealer regarding the version update to the latest rmware if the version is earlier than 2.00.
For details on how to conrm the rmware version, refer to “How to conrm the rmware version of the Interface Board (optional)”
(x page 33).
How to conrm the rmware version of the Interface Board (optional)
r Interface Board for HDMI 2 input (Model No.: ET-MDNHM10)
The Interface Board for HDMI 2 input with the rmware version 2.00 or later has the version displayed on the
product.
The rmware version can also be conrmed in the [STATUS] screen. (x page 167)
Ver. 2.00
Firmware version 2.00
Display example
r 3G-SDI Terminal Board with Audio (Model No.: TY-TBN03G)
The 3G-SDI Terminal Board with Audio with the rmware version 2.00 or later has the version displayed on the
product.
The rmware version can also be conrmed in the [STATUS] screen. (x page 167)
Ver. 2.00
Firmware version 2.00
Display example
To Next Page
Loading...
