Panasonic PT-RZ990 - Page 130

Chapter 4 Settings — [PROJECTOR SETUP] menu
130 - ENGLISH
5) Press
as
to select [APPLY].
6) Press the <ENTER> button.
f
The conrmation screen is displayed.
7) Press
qw
to select [OK], and press the <ENTER> button.
Note
f
The [OPERATING MODE] setting does not return to factory default setting even if the [PROJECTOR SETUP] menu
→
[INITIALIZE]
→
[ALL
USER DATA] is executed.
f
When [OPERATING MODE] is set to [LONG LIFE1], [LONG LIFE2] or [LONG LIFE3], the [PROJECTOR SETUP] menu
→
[BRIGHTNESS
CONTROL]
→
[BRIGHTNESS CONTROL SETUP]
→
[CONSTANT MODE] automatically switches to [AUTO] and the items of [OPERATION
SETTNIG] cannot be selected.
f
If the consolidated runtime of the projector exceeds 20 000 hours, replacement of the components inside the projector may be required. The
consolidated runtime can be conrmed in the
[STATUS]
screen. Refer to the [PROJECTOR SETUP] menu
→
[STATUS] for details.
Setting [MAX LIGHT OUTPUT LEVEL]
Adjust the maximum level to correct screen brightness according to the changes in brightness of the light source.
1) Press
as
to select [OPERATION SETTING].
2) Press the <ENTER> button.
f
The
[OPERATION SETTING]
screen is displayed.
3) Press
as
to select [MAX LIGHT OUTPUT LEVEL].
4) Press
qw
to adjust.
Operation Adjustment Range of adjustment
Press
w
. Increases the maximum level of brightness correction.
8.0 % - 100.0 %
Press
q
. Decreases the maximum level of brightness correction.
5) Press
as
to select [APPLY].
6) Press the <ENTER> button.
f
The conrmation screen is displayed.
7) Press
qw
to select [OK], and press the <ENTER> button.
Note
f
When [OPERATING MODE] is set to [NORMAL], [ECO], [QUIET1], [QUIET2], [LONG LIFE1], [LONG LIFE2] or [LONG LIFE3], the item of
[MAX LIGHT OUTPUT LEVEL] cannot be adjusted.
f
The brightness is corrected using this setting when the [PROJECTOR SETUP] menu
→
[BRIGHTNESS CONTROL]
→
[BRIGHTNESS
CONTROL SETUP]
→
[CONSTANT MODE] is set to [AUTO] or [PC].
f
The [MAX LIGHT OUTPUT LEVEL] setting does not return to factory default setting even if the [PROJECTOR SETUP] menu
→
[INITIALIZE]
→
[ALL USER DATA] is executed.
Setting [LIGHT OUTPUT]
Adjust the brightness of light source.
The [LIGHT OUTPUT] setting is synchronized with the [PROJECTOR SETUP] menu
→
[LIGHT OUTPUT]. The
most recent setting is reected in both items.
1) Press
as
to select [OPERATION SETTING].
2) Press the <ENTER> button.
f
The
[OPERATION SETTING]
screen is displayed.
3) Press
as
to select [LIGHT OUTPUT].
4) Press
qw
to adjust.
Operation
Adjustment
Range of adjustment
Brightness Runtime (estimate)
Press
w
. The screen becomes brighter. The runtime becomes shorter.
8.0 % - 100.0 %
Press
q
. The screen becomes darker. The runtime becomes longer.