Panasonic PT-RZ990

Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 65
When the administrator account setting screen is displayed
When the projector is switched on for the rst time after purchase, as well as when the [PROJECTOR SETUP]
menu
→
[INITIALIZE]
→
[ALL USER DATA] is executed, the focus adjustment screen is displayed after
projection starts, and then the
[INITIAL SETTING]
screen and the
[ADMINISTRATOR ACCOUNT]
screen are
displayed. When the [PROJECTOR SETUP] menu
→
[INITIALIZE]
→
[NETWORK/E-MAIL] is executed, the
[ADMINISTRATOR ACCOUNT]
screen is displayed after projection starts.
To use the network function of this projector, set the user name and password of the administrator account. You
can also set it later from the [NETWORK] menu
→
[ADMINISTRATOR ACCOUNT].
dispadmin
ADMINISTRATOR ACCOUNT
SUB MENU
MENU SELECT
PASSWORD POLICY
ENTER
USER NAME
PASSWORD
PASSWORD CONFIRM
STORE
Please set the user name and password.
if not set,
could not use the Web Control function
and for communication control via a LAN
(including Panasonic application software).
[PASSWORD POLICY]
Displays the policies about the password for the administrator account.
1) Press
as
to select [PASSWORD POLICY], and press the <ENTER> button.
f
The
[PASSWORD POLICY]
screen is displayed.
f
Pressing the <MENU> button can return to the
[ADMINISTRATOR ACCOUNT]
screen.
PASSWORD POLICY
RETURN
MENU
Reusing passwords is not recommended.
Password cannot be blank.
A password consisting of at least eight
half-width characters and contaning
characters of at least three of the
following four types is recommended.
Uppercase letters
Lowercase letters
Digits
Symbols(~!@#$%^&*()_+\|}{][<>.,/?)
Setting the administrator account
Set the user name and password of the administrator account.
1) Press
as
to select [USER NAME], and press the <ENTER> button.
f
The
[USER NAME]
screen is displayed.
f
The factory default setting of user name is "dispadmin".
2) Press
asqw
to select a character, and press the <ENTER> button.
f
Up to 16 characters can be entered.
3) After entering the user name, press
asqw
to select [OK], and press the <ENTER> button.
f
The
[ADMINISTRATOR ACCOUNT]
screen is displayed.
4) Press
as
to select [PASSWORD], and press the <ENTER> button.
f
The
[PASSWORD]
screen is displayed.