Panasonic PT-RZ990

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 155
3) Enter a security password and press the <ENTER> button.
f
The
[DATA CLONING]
screen is displayed.
4) Press
as
to select [WRITE PROTECT].
5) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Permits operations of the data cloning function from another projector.
[ON]
Does not permit the operations of the data cloning function from another projector.
f
Data copy will not be possible when [ON] is set. When it is not necessary to copy data of another
projector, set to [ON] so that the data is not changed by mistake.
Note
f
The security password is the password set in the [SECURITY] menu
→
[SECURITY PASSWORD CHANGE].
Initial password as the factory default:
awsqawsq
[SAVE ALL USER DATA]
Save the various setting values as a backup in the built-in memory of the projector.
1) Press
as
to select [SAVE ALL USER DATA].
2) Press the <ENTER> button.
f
The
[SECURITY PASSWORD]
screen is displayed.
3) Enter a security password and press the <ENTER> button.
f
The conrmation screen is displayed.
4) Press
qw
to select [OK], and press the <ENTER> button.
f
[PROGRESS] is displayed while saving data.
Note
f
Data set from the computer application is not included in [ALL USER DATA].
f
The data saved by executing [SAVE ALL USER DATA] is not deleted even if the [PROJECTOR SETUP] menu
→
[INITIALIZE]
→
[ALL
USER DATA] is executed.
[LOAD ALL USER DATA]
Load the various setting values saved as a backup in the built-in memory of the projector.
1) Press
as
to select [LOAD ALL USER DATA].
2) Press the <ENTER> button.
f
The
[SECURITY PASSWORD]
screen is displayed.
3) Enter a security password and press the <ENTER> button.
f
The conrmation screen is displayed.
4) Press
qw
to select [OK], and press the <ENTER> button.
Note
f
The projector enters the standby mode to reect the setting values when [LOAD ALL USER DATA] is executed.
f
Data registered from a computer is not included in [ALL USER DATA].
[INITIALIZE]
Return various setting values to their factory default settings.
1) Press
as
to select [INITIALIZE].
2) Press the <ENTER> button.
f
The
[SECURITY PASSWORD]
screen is displayed.
3) Enter a security password and press the <ENTER> button.
f
The
[INITIALIZE]
screen is displayed.