Panasonic PT-RZ990

Chapter 3 Basic Operations — Switching on/off the projector
68 - ENGLISH
Switching off the projector
1)
2)
1)
4)
3)
2)
1) Press the power standby <
v
> button.
f
The
[POWER OFF(STANDBY)]
conrmation screen is displayed.
2) Press
qw
to select [OK], and press the <ENTER> button.
(Or press the power standby <
v
> button again.)
f
Projection of the image will stop, and the power indicator <ON (G)/STANDBY (R)> on the projector body
lights orange. (The fan keeps running.)
3) Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> of the projector body lights/
blinks red.
4) Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Note
f
For approximately ve seconds after the projector is turned off, the indicator does not light up even if the power is turned on.
f
Even when the power standby <
v
> button is pressed and the projector is switched off, the projector consumes power if the main
power of the projector is on.
Usage of some functions is restricted but the power consumption during the standby mode is conserved when the [PROJECTOR SETUP]
menu
→
[STANDBY MODE] is set to [ECO].
f
While projecting, the power can be turned off by pressing the <OFF> side of the <MAIN POWER> switch, or by directly using the breaker
under conditions where the <MAIN POWER> switch of the projector cannot be switched off/on easily such as while installing on the ceiling.
However, the settings or adjustments performed right before the power is turned off may not be reected.