Panasonic PT-RZ990

Chapter 7 Appendix — Technical information
216 - ENGLISH
r
COLOR, TINT
Performance Parameter Default value
No operation 0-31
0
Factory default setting 32-63
- 31 64-65
… …
0 128-129
… …
+31 190-191
No operation 192-255
r
RASTER PATTERN
Performance Parameter Default value
No operation 0-15
0
OFF 16-31
WHITE 32-47
YELLOW 48-63
CYAN 64-79
GREEN 80-95
MAGENTA 96-111
RED 112-127
BLUE 128-143
BLACK 144-159
USER LOGO 160-175
No operation 176-255
r
ENABLE/DISABLE
Operation for all channels is not accepted when set to “Disable”.
Performance Parameter Default value
Disable 0-127
0
Enable 128-255
Note
f
If the projector is operated using the remote control or the control panel, or by the control command while controlling the projector using the
Art-Net function, the setting of the DMX controller or computer application may be different from the projector status. To reect the controls
of all channels to the projector, set “ENABLE/DISABLE” of channel 11 to “Disable” and then back to “Enable”.
f
To create and register the USER LOGO image, use “Logo Transfer Software”.
The software can be downloaded from the Panasonic website (https://panasonic.net/cns/projector/).
Control commands via LAN
The projector can be controlled via the <DIGITAL LINK/LAN> terminal or the <LAN> terminal by using the control
command format via the <SERIAL/MULTI PROJECTOR SYNC IN> terminal.
For examples of the available commands, refer to “Control command” (
x
page 222).
Note
f
Setting the password of the administrator account is required for (
x
page 168) sending and receiving the commands via LAN.
Connecting
1) Obtain the IP address and port number (Initial set value = 1024) of the projector and request a
connection to the projector.
f
You can obtain both the IP address and the port number from the menu screen of the projector.
IP address
Obtain from the [NETWORK] menu
→
[NETWORK STATUS].
Port number
Obtain from the [NETWORK] menu
→
[NETWORK CONTROL]
→
[COMMAND PORT].