Panasonic PT-RZ990

Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 59
When the initial setting screen is displayed
When the projector is switched on for the rst time after purchase, as well as when the [PROJECTOR SETUP]
menu
→
[INITIALIZE]
→
[ALL USER DATA] is executed, the focus adjustment screen is displayed after
projection starts, and then the
[INITIAL SETTING]
screen and the
[ADMINISTRATOR ACCOUNT]
screen
are displayed. When the [PROJECTOR SETUP] menu
→
[INITIALIZE]
→
[NETWORK/E-MAIL] is executed,
the
[ADMINISTRATOR ACCOUNT]
screen is displayed after projection starts. Set them according to the
circumstances.
In other occasions, you can change the settings by menu operations.
If you press the <MENU> button while the
[INITIAL SETTING]
screen is displayed, you can go back to the
previous screen.
Focus adjustment
Adjust the focus to display the menu screen clearly.
Adjustment of the zoom and shift may also be necessary.
Refer to “Adjusting the focus, zoom, and lens shift” (
x
page 70) for details.
1) Press
asqw
to adjust the focus.
LENS
FOCUS
ADJUST
2) Press the <MENU> button to proceed to the initial setting.
Initial setting (display language)
Select the language to show on the screen.
After completed the initial setting, you can change the display language from the [DISPLAY LANGUAGE] menu.
1) Press
as
to select the display language.
ENTER
1/7
Please select DISPLAY LANGUAGE.
INITIAL SETTING
SELECT
SET
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (operation setting)
Set the items regarding the operating method depending on the duration of use and the usage of the projector.
After completed the initial setting, you can change the settings of each item from the [PROJECTOR SETUP] menu
→
[OPERATION SETTING]. If you change the settings while using the projector, the duration until the luminance
decreases by half may shorten or the luminance may decrease.
This initial setting (operation setting) is prepared to complete the settings at once during the installation when the
operation of the projector is predetermined.
This cannot set all the items regarding the operation setting. When the detailed setting is required or setting
change is required, ask the person responsible for this projector (such as a person in charge of equipment or
operation).