Panasonic PT-RZ990

Chapter 4 Settings — [NETWORK] menu
172 - ENGLISH
13) Press
as
to select [STORE], and press the <ENTER> button.
f
The conrmation screen is displayed.
14) Press
qw
to select [OK], and press the <ENTER> button.
Note
f
The PJLink password can also be changed on the [Set up password] page (
x
page 192) of the web control screen.
[PJLink CONTROL]
Set to enable or disable the PJLink protocol control function.
1) Press
as
to select [PJLink].
2) Press the <ENTER> button.
f
The
[PJLink]
screen is displayed.
3) Press
as
to select [PJLink CONTROL].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[ON]
Enables PJLink protocol control function.
[OFF]
Disables PJLink protocol control function.
[PJLink NOTIFICATION]
Set to enable or disable the PJLink notication function.
1) Press
as
to select [PJLink].
2) Press the <ENTER> button.
f
The
[PJLink]
screen is displayed.
3) Press
as
to select [PJLink NOTIFICATION].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Disables the PJLink notication function.
[ON]
Enables the PJLink notication function.
f
If [ON] is selected, proceed to Step
5)
.
5) Press
as
to select [NOTIFIED IP ADDRESS 1] or [NOTIFIED IP ADDRESS 2].
f
Enter the IP address of the computer to notify the status of the projector.
[Art-Net]
Set the Art-Net function.
Setting the password of the administrator account is required (
x
page 168) for using the Art-Net function of the
projector.
Note
f
If the password of the administrator account has not been set, that is, if it is left blank, the network function of this projector cannot be used.
Set a password before using the web control function or the communication control (including operation with application software) via LAN.
[Art-Net SETUP]
Make settings to use the Art-Net function.
1) Press
as
to select [Art-Net].
2) Press the <ENTER> button.
f
The
[Art-Net]
screen is displayed.
3) Press
as
to select [Art-Net SETUP].