Panasonic PT-RZ990

Chapter 3 Basic Operations — Switching on/off the projector
60 - ENGLISH
2/7
100.0%
INITIAL SETTING
SET
CHANGEMENU SELECT
OPERATING MODE
NORMAL
ENTER
LIGHT OUTPUT
Set the way to use the projector.
For details, please refer to the
operating instructions "When the
initial setting screen is displayed".
Note
f
For the relationship between the luminance and the runtime, refer to “Relationship between brightness and runtime” (
x
page 61).
f
For details on each setting item, refer to the [PROJECTOR SETUP] menu
→
[OPERATION SETTING].
1) Press
as
to select [OPERATING MODE].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
f
Set [OPERATING MODE] to [NORMAL], [USER1], [USER2], or [USER3] when using the projector at an
altitude of 2 700 m (8 858') or higher above sea level.
[NORMAL]
Set this item when high luminance is required. The estimated runtime is approximately 20 000 hours
*1
.
[ECO]
The luminance will decrease compared to [NORMAL], but set this item to increase the expected life of
the light source. The estimated runtime is approximately 24 000 hours
*1
.
[QUIET1]
*3
The luminance will decrease compared to [NORMAL], but select this item when operation with low
noise is prioritized. The estimated runtime is approximately 20 000 hours
*1
.
[QUIET2]
*3
The luminance will decrease compared to [QUIET1], but select this item when operating the projector
with less noise. The estimated runtime is approximately 20 000 hours
*1
.
[LONG LIFE1]
The luminance will decrease compared to [ECO], but set this item to increase the expected life of the
light source. The estimated runtime is approximately 43 000 hours
*2
.
[LONG LIFE2]
The luminance will decrease compared to [LONG LIFE1], but set this item to increase the expected
life of the light source. The estimated runtime is approximately 61 000 hours
*2
.
[LONG LIFE3]
The luminance will decrease compared to [LONG LIFE2], but set this item to increase the expected
life of the light source. The estimated runtime is approximately 87 000 hours
*2
.
[USER1]
[LIGHT OUTPUT] can be set individually.
[USER2]
[USER3]
*1 Estimated runtime is the time until the brightness decreases to approximately half of the time of delivery when the projector is used with the
[PICTURE] menu
→
[DYNAMIC CONTRAST] set to [3] and under environment of 0.15 mg/m
3
dust.
The value of runtime is just an estimate, and is not the warranty period.
*2 Estimated runtime is the time until the brightness decreases to approximately half of the time of delivery when the projector is used with the
[PICTURE] menu
→
[DYNAMIC CONTRAST] set to [3].
The value of runtime is just an estimate, and is not the warranty period.
*3 Only for PT-RZ990 / PT-RZ890
3) Press
as
to select [LIGHT OUTPUT].
4) Press
qw
to adjust.
Operation
Adjustment
Range of adjustment
Brightness Runtime (estimate)
Press
w
. The screen becomes brighter. The runtime becomes shorter.
8.0 % - 100.0 %
Press
q
. The screen becomes darker. The runtime becomes longer.
5) Press the <ENTER> button to proceed to the initial setting.