Panasonic PT-RZ990

Chapter 4 Settings — [PROJECTOR SETUP] menu
154 - ENGLISH
f
“[Authentication set up] page” (
x
page 189) in the web control screen
f
“[Crestron Connected(TM)] page” (
x
page 194) in the web control screen
Note
f
The data cloning function will not operate when the models of the projectors are different. For example, data of PT-RZ990 can be copied to
other PT-RZ990 projectors, but it cannot be copied to PT-RZ890. Data cloning is limited to the same model.
Copying data to another projector
Set the administrator account password (
x
page 168) of all the projectors in advance.
Set the following settings on the projector of the copy destination in advance. Refer to “Setting [WRITE
PROTECT]” (
x
page 154) for details.
f
The [PROJECTOR SETUP] menu
→
[DATA CLONING]
→
[WRITE PROTECT]
→
[OFF]
1) Connect all projectors to the switching hub using LAN cables. (
x
page 176)
2) Turn on all the projectors.
3) Press
as
to select [DATA CLONING] on the copy source projector.
4) Press the <ENTER> button.
f
The
[SECURITY PASSWORD]
screen is displayed.
5) Enter a security password and press the <ENTER> button.
f
The
[DATA CLONING]
screen is displayed.
6) Press
as
to select [SELECT PROJECTOR].
7) Press the <ENTER> button.
f
The projectors in the same subnet are displayed as a list.
8) Press
as
to select the copy destination projector.
9) Press the <ENTER> button.
f
To select multiple projectors, repeat Steps
8)
to
9)
.
10) Press the <DEFAULT> button on the remote control.
f
The conrmation screen is displayed.
11) Press
qw
to select [OK], and press the <ENTER> button.
f
Start the copy of data between projectors.
Once the copy is completed, results are displayed as a list in the
[DATA CLONING]
screen.
Meanings of the marks displayed in the list are as follows.
g
Green: Data copy has succeeded.
g
Red: Data copy has failed. Conrm the connection of the LAN cable, power status and administrator
account password of the copy destination projector.
f
The copy destination projector will display the data cloning request message, transfer to standby state
automatically, and perform the copy of the data.
12) Turn on the copy destination projector.
f
The copied content is reected to the projector.
Note
f
The security password is the password set in the [SECURITY] menu
→
[SECURITY PASSWORD CHANGE].
Initial password as the factory default:
awsqawsq
f
The light source indicator <LIGHT1>/<LIGHT2> and the temperature indicator <TEMP> of the copy destination projector blink while copying
the data. Conrm the blinking of the indicators stops, and then turn on the power supply.
Setting [WRITE PROTECT]
Set if the copy of data using the data cloning function is permitted or not.
1) Press
as
to select [DATA CLONING] on the copy destination projector.
2) Press the <ENTER> button.
f
The
[SECURITY PASSWORD]
screen is displayed.