Projector settings
1) Turn on the projector.
2) Press the <MENU> button to display the [NETWORK/USB] menu, and then press <ENTER> button.
3) Press as to select [WIRELESS LAN].
4) Press qw to select [SIMPLE] or [NORMAL].
5) Press the <ENTER> button.
f The [WIRELESS LAN] screen is displayed.
6) According to the network number selected in step 4), set the [WIRELESS DETAILED SETUP].
f For details, see “WIRELESS DETAILED SETUP”. (Æ page 91)
Note
f Wireless LAN and wired LAN cannot be used in the same segment.
f When multiple devices are connected, a unique IP ADDRESS must be allocated to each device.
f SSID has to be entered in alphanumeric letters.
f You cannot set “any” or “ANY” for SSID.
f The projector settings are not required when Miracast is connected. For details about Miracast, please refer to
page 125.
f The following settings are set before the projector leaves the factory.
[SIMPLE]
[KEY] proj + The last 4 digits of the network ID
[NORMAL] → [M-DIRECT]
[IP ADDRESS] 192.168.12.100
[SUBNET MASK] 255.255.255.0
[SSID] M-DIRECT + The last 4 digits of the network ID
[CHANNEL] 1
[KEY] The same string as the SSID
[NORMAL] → [USER1] ~ [USER3]
[SSID] Panasonic Projector
[DHCP] OFF
[IP ADDRESS] 192.168.11.100
[SUBNET MASK] 255.255.255.0
[DEFAULT GATEWAY] 192.168.11.1
[AUTHENTICATION] OPEN
[ENCRYPTION] NONE
[DNS1] / [DNS2] NONE
Computer settings
1) Turn on the computer.
2) Make the network setting according to your system administrator.
f If you select [M-DIRECT] in [WIRELESS LAN], the IP address will automatically be acquired.
f If you select [USER1] ~ [USER3] in [WIRELESS LAN], then make the network settings for the computer and the
projector according to your system administrator.
3) Connect the computer to the network that has been set for the projectors.
f If you use a Windows computer, click on the task tray (bottom right of the Windows screen), then select the same
name as the SSID that has been set in the projector when you select [M-DIRECT] in [WIRELESS LAN], or select the
same name as the SSID that is used in current access point when you select [USER1] ~ [USER3] in [WIRELESS LAN].
If you use a Mac computer, click
on the menu bar (top right of the Mac screen), then select the same name as the
SSID that has been set in the projector.
f When you select default settings of [M-DIRECT] for [WIRELESS LAN] in the network menu, the SSID is [M-DIRECT +
The last 4 digits of the network ID].
ENGLISH - 101
Chapter 4 Settings - [NETWORK/USB] menu
To Next Page
Loading...
