Panasonic PT-VW535N

[PROJECTOR SETUP] menu
On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the submenu.
Refer to "Navigating through the menu" (
Æ page 53) for the operation of the menu screen.
fAfter selecting the item, press asqw to set.
[STATUS]
You can check the using status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
[SIGNAL]
[NAME] Displays the name of input signal.
[FREQUENCY] Displays the scanning frequency of input signal.
[RUNTIME]
*
1
[PROJECTOR] Displays the current usage time of projector.
[LAMP (ET-LAV400*
2
)]
Displays the model No. of the replacement lamp unit for this
projector.
[NORMAL]
Displays the lamp runtime when [LAMP POWER] is set to
[NORMAL] by actual time.
[ECO]
Displays the lamp runtime when [LAMP POWER] is set to [ECO]
by actual time.
[SERIAL NUMBER] [PROJECTOR] Displays the serial number of the projector.
*1 The following conversion is required to calculate the rough estimate for lamp replacement.
Formula for lamp replacement time (rough estimate)
A × 1 + B × 5/7
f A : Runtime which is displayed in [STATUS] screen → [RUNTIME] → [LAMP] → [NORMAL]
f B : Runtime which is displayed in [STATUS] screen → [RUNTIME] → [LAMP] → [ECO]
*2 The model No. of the optional lamp unit is subject to change without prior notice.
[COMPUTER1 INPUT SETTING]
Set whether to use the <COMPUTER 1 IN> terminal.
1) Press as to select [COMPUTER1 INPUT SETTING].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[RGB/YP
B
P
R
] Select when you want to input the RGB or YP
B
P
R
(YC
B
C
R
) signal to <COMPUTER 1 IN> terminal.
[Y/C] Select when you want to input a luminance signal and a color signal to <COMPUTER 1 IN> terminal.
[COMPUTER2 SELECT]
Set whether to use the <COMPUTER 2 IN/1 OUT> terminal.
1) Press as to select [COMPUTER2 SELECT].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[COMPUTER2 IN] When input the computer signal.
[COMPUTER1 OUT] Outputs the signal which has been input <COMPUTER 1 IN> terminal.
78 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu