Panasonic PT-VW535N

3) Press as to select an item, and change the setting according to the instructions.
[DHCP]
[ON]: If a DHCP server exists in the network to which the projector is connected,
the IP address will automatically be acquired.
[OFF]: If a DHCP server does not exist in the network to which the projector is
connected, additionally set [IP ADDRESS], [SUBNET MASK] and
[DEFAULT GATEWAY].
[IP ADDRESS] Enter the IP address if DHCP server is not used.
[SUBNET MASK] Enter the subnet mask if DHCP server is not used.
[DEFAULT GATEWAY] Enter the gateway address if DHCP server is not used.
[DNS1] Enter the DNS server address if DHCP server is not used.
[DNS2] Enter the alternate DNS server address if DHCP server is not used.
4) Press as to select [OK], and press the <ENTER> button.
r Default wired LAN settings
f The following settings are set before the projector leaves the factory.
[DHCP] OFF
[IP ADDRESS] 192.168.10.100
[SUBNET MASK] 255.255.255.0
[DEFAULT GATEWAY] 192.168.10.1
[DNS1] / [DNS2] NULL
Note
f Before using the DHCP server, make sure the DHCP server is already functioning.
f Consult your network administrator regarding the IP ADDRESS, SUBNET MASK, and DEFAULT GATEWAY.
f A wired LAN and wireless LAN cannot be used in the same segment.
[WIRELESS LAN]
Set the connections of wireless LAN.
1) Press as to select [WIRELESS LAN].
2) Press qw to select the connection method.
[DISABLE] When do not use the wireless LAN function.
[SIMPLE]
Simple connection mode that can be compatible with all OS (Windows / Mac / iOS / Android etc.).
Use the wireless LAN function via the application software which supports “Wireless Manager ME6.2”,
iPad / iPhone / iPod touch and Android devices.
[NORMAL]
[S-DIRECT]
Use this setting when use the wireless LAN function via the software
"Wireless Manager ME6.2" of the supplied CD-ROM which supports
Windows and Mac computer.
[M-DIRECT]
Use this setting when the projector is used as a simple access point.
Even if there is no access point, the connection is enabled. Use the
wireless LAN function via the application software which supports
“Wireless Manager ME6.2”, iPad / iPhone / iPod touch and Android
devices. Connection with the Android devices and iPad / iPhone /
iPod touch will be easier.
For details, refer to the following “Detailed setup of [M-DIRECT]”.
[USER1] / [USER2] / [USER3]
To match your network environment, set the detailed setup of
network.
For details, refer to the following “Detailed setup of [USER1] /
[USER2] / [USER3]”.
Note
f Projectors that can be connected to [SIMPLE], [S-DIRECT] or [M-DIRECT] are up to 10.
f When [WIRELESS LAN] is set to [SIMPLE], [S-DIRECT] or [M-DIRECT] and the input signal is other than [Panasonic
APPLICATION], the normal wireless connection is disabled.
f Even if [WIRELESS LAN] is set to [SIMPLE], [S-DIRECT] or [M-DIRECT], when switch to input Miracast signal it will be
disabled.
f For more information on how to use the application software “Wireless Manager ME6.2”, refer to the operating instructions of
“Wireless Manager ME6.2”.
90 - ENGLISH
Chapter 4 Settings - [NETWORK/USB] menu