Panasonic PT-VW535N

1) Press as to select [VueMagic(TM)].
2) Press qw to display the VueMagic idle screen.
f The VueMagic idle screen is displayed.
Note
f When using the VueMagic application, the projector settings are required to set [USER1] ~ [USER3] as mode of wireless
LAN. For more information, please refer to “Detailed setup of [USER1] / [USER2] / [USER3]” (x page 92).
f For information about working with VueMagic application, refer to the Operating Instructions of your device.
f When the input is switched or the <MENU> button is pressed, the [VueMagic(TM)] will switch to [OFF] automatically.
f When you are viewing a VueMagic idle screen, MENU screen cannot be displayed.
f When connecting to the iOS device or Android device, you must install the dedicated application “VueMagic” to the device.
For detailed information, refer to the following web site. (Only in English.)
URL http://vuemagic.pixelworks.com
[STATUS]
Displays the current network status.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen (WIRED LAN 1/3) is displayed.
3) Press as to switch between the screen (WIRED LAN 1/3 → WIRELESS LAN 2/3 → WIRELESS LAN 3/3).
f The page will switch each time you press the button.
[WIRED LAN] Displays the network information of the wired LAN that set on the projector.
[DHCP] Displays the usage state of the DHCP server.
[IP ADDRESS] Displays the IP address.
[SUBNET MASK] Displays the subnet mask.
[DEFAULT GATEWAY] Displays the default gateway.
[DNS1] Displays the address of the primary DNS server.
[DNS2] Displays the address of the secondary DNS server.
[MAC ADDRESS] Displays the MAC address of wired LAN.
[WIRELESS LAN] Displays the network information of the wireless LAN that set on the projector.
[ANTENNA LEVEL] Displays the radio wave state of the wireless LAN.
[NETWORK] Displays the connection method of the wireless LAN.
[SSID] Displays the character string of SSID.
[AUTHENTICATION] Displays the user authentication method.
[EAP] Displays the type of EAP.
[ENCRYPTION] Displays the encryption method.
[DEFAULT KEY] Displays the number of the default key.
[DHCP] Displays the usage state of the DHCP server.
[IP ADDRESS] Displays the IP address.
[SUBNET MASK] Displays the subnet mask.
[DEFAULT GATEWAY] Displays the default gateway.
[DNS1] Displays the address of the primary DNS server.
[DNS2] Displays the address of the secondary DNS server.
[MAC ADDRESS] Displays the MAC address of wireless LAN.
Note
f When [WIRELESS LAN] is set to [DISABLE], the [STATUS] screen of the wireless LAN will not be displayed.
[INITIALIZE]
This function is used to return various setting values of [NETWORK/USB] to the factory default value.
1) Press as to select [INITIALIZE].
2) Press the <ENTER> button.
f The [INITIALIZE] screen is displayed.
3) Press qw to select [OK] and then press the <ENTER> button.
ENGLISH - 97
Chapter 4 Settings - [NETWORK/USB] menu