Panasonic PT-VW535N

Applicable
scanning
frequency
For HDMI signal
525i(480i)*
2
, 625i(576i)*
2
, 525p(480p), 625p(576p), 750(720)/60p, 750(720)/50p,
1125(1080)/24p, 1125(1080)/24sF, 1125(1080)/25p, 1125(1080)/30p, 1125(1080)/60p,
1125(1080)/50p, 1125(1080)/60i, 1125(1080)/50i
Displayable resolution: VGA to WUXGA (non-interlace)
Dot clock frequency: 25 MHz to 162 MHz
Color system 7 (NTSC, NTSC4.43, PAL, PAL-N, PAL-M, SECAM, PAL60)
Projection size 0.76 m -7.62 m (30"-300")
Screen aspect ratio
PT-VZ575N, PT-VW535N 16:10
PT-VX605N 4 : 3
Projection scheme
[FRONT/DESK], [FRONT/CEILING], [REAR/DESK], [REAR/CEILING]
(Menu setting system)
Speaker 1 (4.0 cm round-type)
Maximum usable volume output 10 W
Terminals
<COMPUTER 1 IN>
1 set, high-density D-Sub 15 p (female)
[RGB signal] 0.7 V [p-p] 75 Ω (When G-SYNC: 1.0 V [p-p] 75 Ω)
HD/SYNC TTL high impedance, automatic positive/negative polarity
compatible
VD TTL high impedance, automatic positive/negative polarity compatible
(SYNC/HD and VD do not support 3 value SYNC.)
[YP
B
P
R
signal] Y: 1.0 V [p-p] including synchronization signal, P
B
P
R
: 0.7 V [p-p] 75 Ω
[Y/C signal] Y: 1.0 V [p-p], C: 0.286 V [p-p] 75 Ω
<COMPUTER 2 IN/
1 OUT>
1 set, high-density D-Sub 15 p (female)
[RGB signal] 0.7 V [p-p] 75 Ω (When G-SYNC: 1.0 V [p-p] 75 Ω)
HD/SYNC TTL high impedance, automatic positive/negative polarity
compatible
VD TTL high impedance, automatic positive/negative polarity compatible
(SYNC/HD and VD do not support 3 value SYNC.)
[YP
B
P
R
signal] Y: 1.0 V [p-p] including synchronization signal, P
B
P
R
: 0.7 V [p-p] 75 Ω
<VIDEO IN> 1 set, pin jack 1.0 V [p-p] 75 Ω
<HDMI 1 IN> /
<HDMI 2 IN>
2 set (HDMI 19 pin, HDCP and Deep color compatible)
Audio signals: Linear PCM (Sampling frequency: 48 kHz/44.1 kHz/32 kHz)
<AUDIO IN>
2 set (M3 stereo mini jack, 0.5 V [rms], input impedance 22 kΩ and more)
(<AUDIO IN 2 (MIC IN)> terminal support MIC input)
1 set (Pin jack x 2 (L-R), 0.5 V [rms], input impedance 22 kΩ and more)
<VARIABLE AUDIO
OUT>
1 set (M3 stereo mini jack, stereo monitor output compatible,
0 V [rms] to 2.0 V [rms] variable, output impedance 2.2 kΩ and less)
<USB A (VIEWER)> 1 set USB connector (type A x 1)
<USB B (DISPLAY)>
1 set USB connector (type B x 1)
<SERIAL IN> 1 set (D-sub 9 pin, RS-232C compliant, for computer control use)
<DIGITAL LINK/
LAN>
1 set, RJ-45, for network, DIGITAL LINK connection, PJLink compatible, 100Base-TX
ENGLISH - 147
Chapter 7 Appendix - Specications