Panasonic SC-HT290

RQT5822
18
B
C
A
SPEAKERS
SOUND MODE
STEREO
LR
SPEAKERS
DIGITAL
SOUND MODE
SURROUND
LCR
LS LFE RS
PCM
FIXED
FIXED
DSP SOUND MODE
DSP SOUND MODE
DIGITAL INPUT
DSP
SOUND MODE
DIGITAL INPUT
DSP sound modes
The digital sound processor (DSP) in the receiver can decode Dolby
Digital and DTS signals. It automatically determines the type of signal,
PCM, Dolby Digital or DTS, and processes it accordingly.
The DSP can add surround-like effects to stereo sources (analog or
PCM signals).
Choose from the STEREO, SURROUND, or SFC modes.
The DSP may interfere with radio reception. You can turn it off if this
occurs (á page 23).
Output is in stereo when you turn the DSP off so sound is only heard
through the front speakers.
Note
³PCM with a sampling frequency of 44.1 kHz is the digital signal for-
mat normally found on CDs. Some DVDs also use this format but
often with a higher sampling rate.
³The receiver cannot process other digital signal formats, such as
MPEG and PCM signals with sampling frequencies of 96 kHz and
192 kHz.
»
A
STEREO mode
Use this mode to play digital or analog stereo sources or to play sur-
round sources through two speakers. When surround sources are
played in this mode, the sounds intended for the other speaker chan-
nels are played through the front speakers.
»
B
SURROUND mode
Select this mode when you are playing a digital surround source
(Dolby Digital or DTS) or an analog source that is recorded with Dolby
Surround (VCR, for example).
»
C
Changing the recognition mode
In rare cases, the receiver may have trouble recognizing the digital
signals on discs. With the PCM signals on CDs, this may cause the
beginning of a track to be cut off. Engage the PCM FIX mode if this
occurs.
With DTS, the signals may not be recognized at all. Engage the DTS
FIX mode if this occurs.
This mode does not need to be changed under normal circumstances.
Change it only if the receiver appears to be having trouble recognizing
the software you are playing.
While the input source is selected and digital input is engaged:
Press and hold [DIGITAL INPUT].
The current mode is displayed. Press again to change the mode.
Each time you press the button:
AUTO>PCM FIX>DTS FIX
^--------------------------------------}
When a FIX mode is on, the receiver cannot process other signals.
This may cause noise to be output.
Select “AUTO” if this occurs.
The selected mode is stored even if the receiver is turned off.