23
RQT5822
Basic operations
The radio
»
A
Manual tuning
You can tune radio stations manually by selecting the station’s fre-
quency, or you can preset up to 30 stations into channels to make
tuning simpler (á page 24).
1 Turn [INPUT SELECTOR] to select
“TUNER”.
2 Press [BAND] to select “FM” or “AM”.
3 Press [TUNING X or W] to select the
frequency of the station.
Tuning intervals: FM–0.2 MHz
AM–10 kHz
“TUNED” lights when tuned.
“STEREO” lights during FM stereo broadcasts.
Automatic tuning
Hold down [TUNING X or W] until the frequency begins to scroll.
Tuning stops when a station is found.
(Tuning may stop if there is interference.)
Improving reception
FM mode
You can improve FM reception by switching reception to monaural.
Press [FM MODE].
“MONO” lights.
Press [FM MODE] again to cancel.
DSP DEFEAT
You can improve reception by turning off the DSP (á page 18).
Press and hold [DSP SOUND MODE] until “DEFEAT” appears.
Press and hold [DSP SOUND MODE] again to turn the DSP on.
For your reference
The changer can interfere with radio reception. Turn the changer off or
move it further away from the antennas if this occurs.
»
B
Direct tuning
Press [TUNER/BAND].
The band changes each time you press the button.
Press [DIRECT TUNING/DISC].
! Press the numbered buttons to enter the fre-
quency.
e.g. To select 107.9 MHz, press [1]>[0]>[7]>[9]
Tuning intervals: FM–0.1 MHz
AM–10 kHz
Note
1. If you do not press a button while the cursor is flashing, the display
returns to the frequency being received.
2. If the frequency has not been input correctly, “ERROR” will be dis-
played.
A
B
1
INPUT SELECTOR
MHz
TUNED
STEREO
MHz
TUNING
BAND
2
3
To Next Page
Loading...
