RQT5822
52
Specifications
Digital input
Optical 2
Coaxial 1
Power consumption in standby mode: 1 W
º FM TUNER SECTION
Frequency range 87.9–107.9 MHz
Sensitivity 11.2 dBf (2 ¬V, IHF’ 58)
50 dB quieting sensitivity
MONO 18.3 dBf (4.5 ¬V, IHF’ 58)
STEREO 38.3 dBf (45 ¬V, IHF’ 58)
Total harmonic distortion
MONO 0.2 %
STEREO 0.3 %
S/N
MONO 73 dB
STEREO 67 dB
Frequency response 20 Hz–15 kHz, i1 dB, j2 dB
Alternate channel selectivity 65 dB
Capture ratio 1.5 dB
Image rejection at 98 MHz 40 dB
Spurious response rejection at 98 MHz 75 dB
AM suppression 50 dB
Stereo separation
1 kHz 40 dB
10 kHz 30 dB
Antenna terminal 75 (unbalanced)
º AM TUNER SECTION
Frequency range 530–1710 kHz
Sensitivity 20 ¬V, 330 ¬V/m
Selectivity 55 dB
IF rejection at 1000 kHz 50 dB
Receiver (IHF’78)
º AMPLIFIER SECTION
Rated minimum sine wave RMS power output
40 Hz–20 kHz both channels driven
0.9 % total harmonic distortion
100 W per channel (6 )
1 kHz continuous power output both channels driven
0.05 % total harmonic distortion 105 W per channel (6 )
Total harmonic distortion
rated power at 40 Hz–20 kHz 0.9 % (6 )
half power at 1 kHz 0.07 % (6 )
Power output at 1 kHz each channel driven
0.9 % total harmonic distortion
Front 2k100 W (6 )
Center 100 W (6 )
Surround 2k100 W (6 )
Subwoofer 100 W (6 )
Low frequency damping factor 30 (6 )
Load impedance
Front 6–8
Center 6–8
Surround 6–8
Subwoofer 6–8
Dynamic headroom 2 dB (6 )
Frequency response
CD, TAPE, DVD, TV, VCR 10 Hz–70 kHz, n3 dB
Input sensitivity
CD, TAPE, DVD, TV, VCR 27 mV (200 mV, IHF’ 66)
S/N (IHF A)
CD, TAPE, DVD, TV, VCR 75 dB
Input impedance
CD, TAPE, DVD, TV, VCR 22 k
Tone controls
BASS 50 Hz, i10 to j10 dB
TREBLE 20 kHz, i10 to j10 dB
Subwoofer frequency response (s6 dB) 7–200 Hz
º VIDEO SECTION
Output voltage at 1 V input (unbalanced) 1n0.1 Vp-p
Maximum input voltage 1.5 Vp-p
Input/output impedance 75
º GENERAL
Power supply AC 120 V, 60 Hz
Power consumption 450 VA, 350 W
Dimensions (WtHtD) 430k158k367 mm
(16–15/16qk6–7/32qk14–15/32q)
Mass 10.5 kC (23.1 lb.)
To Next Page
Loading...
