Panasonic SC-HT290

13
RQT5822
Before use
Do not connect the changer through your
video cassette recorder
The picture may not be played correctly due to the copy guard.
VCR
IN
INOUT
PLAY
(IN)
REC
(OUT)
FRONT
R
L
FM
ANT
AM
ANT
75 Ω
GND
EXT
LOOP
AC IN
AC
OUTLET
DIGITAL IN
CD TAPE
COAXIALOPTICAL2
(DVD)
OPTICAL1
(TV)
TV
CENTER SURROUND
DVD/DVD 6CH
IN
SUBWOOFER
L
R
R
L
IN
TV
MONITOR
OUT
AC IN
OPTICAL
DIGITAL
AUDIO OUT
(PCM/
BITSTREAM)
L
R
SUB-
WOOFER
AUDIO OUT
COMPONENT
VIDEO OUT
VIDEO
OUT
S VIDEO
OUT
Y
P
B
P R
VIDEO
IN
PR
PB
Y
S VIDEO
OUT
A B C
Equipment connections
Stereo connection cable
White (L)
Red (R)
Optical fiber cable (1 included)
Video connection cable (2 included)
S video cable
Make sure that the power supply for all components has been turned
off before making any connections.
To connect equipment, refer to the appropriate operating in-
structions.
Peripheral equipment and cables sold separately unless other-
wise indicated.
Connecting the receiver, changer and TV
TV or monitor
Dust cap
Optical fiber cable connection
³Do not bend the optical fiber cable.
³If the digital optical connector is not going to be used, be sure
to attach the dust cap to prevent exposure to dust.
Changer
Receiver
Optical fiber cable (included)
[A] CENTER, SURROUND (L/R) SUB-
WOOFER IN
Connect a DVD-Audio player with 6-channel
(5.1-channel) output here. When you do this, you
will have to disconnect the changer from the
FRONT terminals.
[B] This connection is necessary if you intend to
record from the changer (á page 34) and to play
audio with high sampling frequencies (á page 25).
[C] If you ever separate the changer from the receiver,
you can connect an active subwoofer here.
º S VIDEO OUT terminal
º COMPONENT VIDEO OUT terminal
S video cable
TV’s S video
input terminal
Video connection cable
TV’s component video
input terminals
PR terminal
P
B terminal
Y terminal
The S-video terminal achieves a more vivid picture than the video output terminal
by separating the chrominance (C) and luminance (Y) signals.
(Actual results depend on the television.)
Connection using these terminals outputs the color difference signals (P
B/PR) and
luminance signal (Y) separately in order to achieve high fidelity in reproducing
colors.
³The description of the component video input terminals depends on the television
or monitor (e.g. Y/P
B/PR, Y/B-Y/R-Y, Y/CB/CR). Connect to terminals of the same
color.
³After making this connection, change the black level for a better picture
(á Video—Black Level Control, page 46).
Video connection cable
(included)
Stereo connection
cable
Video connection cable
(included)