Panasonic SC-HT290

45
RQT5822
Settings
Connection
Setting
No
Yes
Analog
Output as 96 kHz
Converted and
output as 48 kHz
Digital
No output
¤1
Converted and output as
48 kHz/16 bit
Manufactured under license from Dolby Laboratories.
“Dolby” and the double-D symbol are trademarks of Dolby Labo-
ratories. Confidential unpublished works.
Copyrights 1992–1997 Dolby Laboratories. All rights reserved.
¤1
Signals without copyright protection are output as 96 kHz. To enjoy
these sources, however, the other equipment must be able to handle
this sampling frequency.
“DTS” and “DTS Digital Surround” are trademarks of Digital
Theater Systems, Inc.
[DVD]
Digital output
Refer also to “Common procedures” (á page 43) and the Audio section in “Summary of settings” (á page 46).
PCM Down Conversion
No (Factory preset):
When you have connected the receiver with audio cables.
Yes:
When you have connected the receiver with an optical digital audio
cable.
Copyright protection limits digital output to 48 kHz/16 bit.
When playing DVDs recorded in 96 kHz
Sound is output as follows in accordance with the connections and
settings you have made.
Dolby Digital
Bitstream (Factory preset):
When you have connected the receiver.
PCM:
When you have connected a unit that doesn’t have a built-in Dolby
Digital decoder.
¤2
DTS Digital Surround
Off (Factory preset):
When you have connected a unit that doesn’t have a built-in DTS de-
coder.
¤2
(No digital signal is output.)
Bitstream:
When you have connected the receiver.
Manufactured under license from Dolby Laboratories.
“Dolby”, “Pro Logic” and the double-D symbol are trademarks of
Dolby Laboratories. Confidential unpublished works.
+ 1992–1997 Dolby Laboratories. All rights reserved.
Manufactured under license from Digital Theater Systems, Inc.
US Pat. No. 5,451,942 and other world-wide patents issues and
pending. “DTS” and “DTS Digital Surround” are trademarks of
Digital Theater Systems, Inc. + 1996, 2000 Digital Theater
Systems, Inc. All rights reserved.
Changer Receiver
“Dolby”, “Pro Logic” and the double-D symbol are trademarks
of Dolby Laboratories.
¤2
These changes to digital audio output must be made,
otherwise bitstream signals the decoder cannot handle
will be output. If these signals are output, “noise” will
be output which can cause harm to your ears and
speakers.