Panasonic SC-HT290

RQT5822
42
1
2
4
5
3
POWER
DSP SOUND MODE SFC MODE
INPUT SELECTOR
SIZE, DISTANCE, D-INPUT
INPUT SELECTOR
FILTER, DR-COMP, DIMMER
DSP SOUND MODE
DSP SOUND MODE SFC MODE
SFC MODE
1 42·5
34
Receiver settings
Basic steps
If you allow about 10 seconds to elapse between settings, the proce-
dure is canceled, all settings are returned to how they were, and the
previous display is restored. Begin again if this occurs.
1 Press [POWER, ê/I].
2 Press [DSP SOUND MODE] and [SFC
MODE] at the same time.
3 Press [DSP SOUND MODE] to select
the item you want to change.
Each time you press the button:
SIZE>DISTANCE>FILTER>DR COMP
^---=DIMMER(-=D-INPUT(------}
4 Change the settings (á below).
Repeat steps 3 and 4 to complete the necessary
settings.
5 Press [DSP SOUND MODE] and [SFC
MODE] at the same time.
Changing the settings
SIZE
 Press [SFC MODE] to select the speaker you want to set.
Each time you press the button:
FRONT_-)CENTER_-)SURROUND
^-=SUB-WFR (Subwoofer)(--}
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
FRONT: SMALL()LARGE
CENTER and SURROUND: NONE()SMALL()LARGE
SUB-WFR: NO()YES
! Repeat  and to change other SIZE settings.
DISTANCE
 Press [SFC MODE] to select the speaker you want to set.
Each time you press the button:
FRONT>CENTER>SURROUND
^-------------------------------------------}
Turn [INPUT SELECTOR] to set the distance.
! Repeat  and to change other DISTANCE settings.
FILTER
Turn [INPUT SELECTOR] to set the cut-off.
When you turn the selector:
100()150()200
DR COMP
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
OFF()STANDARD()MAX
D-INPUT
 Press [SFC MODE] to select the input position you want to
set.
Each time you press the button:
CD COAX>DVD OPT2>TV OPT1
^-------------------------------------------}
These are the factory settings. Actual displays depend on the
changes you make. If you change one setting, the other corre-
sponding setting will also change.
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
COAX()OPT1()OPT2
^-----------------------------------J
! Repeat  and to change other D-INPUT settings.
DIMMER
Turn [INPUT SELECTOR] to change the setting.
When you turn the selector:
OFF()ON