Panasonic SC-HT290

35
RQT5822
Receiver operations
A
1
2
LR
– +
BASS/TREBLE
BALANCE
–10 dB +10 dB
BASS, TREBLE
BALANCE
B
C
D
SUBWOOFER
LEVEL
SUBWOOFER
FREQUENCY
1
2
1 3 2 4
SUBWOOFER FREQUENCY
SUBWOOFER LEVEL
Other functions
»
A
Using headphones
 Press [SPEAKERS] to turn off the speakers.
Turning the speakers off automatically engages STEREO mode
and ensures no sound is heard from the subwoofer.
(Sound will seem unusual if you use another DSP mode.)
Reduce the volume.
! Connect the headphones
(not included).
Plug type: 6.3 mm (1/4q) stereo
" Adjust the volume.
Note
Avoid listening for prolonged periods of time to prevent hearing
damage.
»
B
Adjusting the tone and balance
You can adjust the tone (BASS and TREBLE) only when the DSP
sound mode is STEREO and input is either analog or PCM. You can
not adjust the tone while the DSP is defeated or if DVD 6CH input is
selected.
1 Press [BASS/TREBLE, BALANCE].
Each time you press the button:
BASS>TREBLE>BALANCE
^--------------------------------------}
BASS: To adjust the bass
TREBLE: To adjust the treble
BALANCE: To adjust the left/right sound balance
2 Press [s, L] or [r, R].
j, L: to lower the selected tone or shift the balance to the left
speaker.
i, R: to raise the selected tone or shift the balance to the right
speaker.
The previous display returns after a few seconds.
»
C
Adjusting the subwoofer level
You can adjust the volume of the subwoofer while listening to a
source. No sound is heard from the subwoofer if “SW ---” is selected.
This setting can be done for each DSP mode.
You cannot adjust the subwoofer level while the DSP is defeated.
The factory setting is “SW 10”.
Press [SUBWOOFER LEVEL].
The current setting is shown.
Each time you press the button:
SW --->SW MIN>SW 5>SW 10>SW 15>SW MAX
^----------------------------------------------------------------------------------------}
To make finer adjustments
 Press [LEVEL] to select “SW”.
Press [j] or [i].
Note
Sound from the subwoofer can be distorted if you raise the receiver’s
volume while subwoofer level is high. Reduce subwoofer level if this
occurs.
»
D
Adjusting the subwoofer low pass
filter
You can adjust the frequency of the subwoofer low pass filter.
Press [SUBWOOFER FREQUENCY].
The current setting is shown.
Press again to change the setting.
Each time you press the button:
50>100>150>200
^------------------------------}
Note
The low pass filter cannot be adjusted while you are playing a Dolby
Digital or DTS source or if the DSP SURROUND mode is on.