21
Operations
VQT4E52
Operations
Using this unit
Preparation
≥ Turn on the TV.
Press [Í] to turn on the
system.
Select the source. (> 6)
≥ This remote control cannot be used to control the
operations of the connected devices.
∫ When “BD/DVD” or “AUX” is selected
as the source
On the connected device:
Select the TV’s input for this unit and start the playback
on the connected device.
Press [i VOL j] to adjust the
volume of the speakers.
≥ Volume range: 1 to 100
§
Press [i SUBWOOFER j] to
adjust the subwoofer level
(bass sound).
≥ Subwoofer levels: 1 to 4
§
(Factory preset: 3)
1 Press [i SUBWOOFER j] to display the
current level.
2 While the level is displayed:
Press [i SUBWOOFER j] to adjust the
level.
§ The audio format indicators blink from left to right (i) or
from right to left (s) while adjusting the speaker volume
or the subwoofer level.The indicators will not blink when
it has reached the maximum or minimum.
∫ To mute the sound
Press [MUTE].
≥ To cancel, press the button again or adjust the
volume.
≥ Muting is cancelled if this system is turned off.
≥ If there is sound from the TV’s speakers too, then use the
TV’s remote control to lower the volume to minimum.
≥ The maximum volume of the TV and this system may be
different.
≥ If this system is turned off with the volume setting in the
greater half (above 50), this system will automatically
lower the volume to the middle (50) when the system is
turned on. (Refer to page 26 to turn this function off.)
Press To select
[TV] “TV”
[BD/DVD] “BD/DVD”
[AUX] “AUX”
Indication Effect level
4 Highest
3
2
1 Lowest
If the system does not operate as expected such as sound defects, return the settings to the
factory preset and operate the system again. (> 26)
The audio format
indicators blink
simultaneously while
muting.
SC-HTB20EBEGGNGS_VQT4E52.book 21 ページ ２０１２年２月２４日 金曜日 午後７時５１分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
