Operations
25
VQT4E52
Advanced operations
Change the dual audio from main to secondary.
1
Confirm the digital audio output setting on the
connected TV or player, etc. is set to “Bitstream”.
2 Press and hold [TV] for more than 2 sec.
3 While the indicator of the current setting is blinking,
press [TV] to change the setting.
≥ The setting works only when the dual audio is
available in the audio source.
≥ The setting is maintained until it is changed again.
≥ The same setting is used for [TV] and [BD/DVD] audio
sources.
This function adjusts the volume automatically when the
volume exceeds a certain level. With this function, you
can prevent sudden loud sounds.
1
Press and hold [AUX] on remote control for more than
2 sec.
≥ The indicator for the current setting blinks for 10 sec.
2 While the indicator is blinking, press [AUX] to
change the setting.
≥ The setting changes each time [AUX] is pressed.
≥ The setting is maintained until it is changed again.
≥ Default setting of this function is OFF.
Depending on your preference, it is possible to use only
the Dolby Virtual Speaker effect by turning off the 3D
surround effect and the clear-mode dialog effect.
1
Press and hold [BD/DVD] on remote controller for
more than 2 sec.
≥ The indicator for the current setting blinks for 10 sec.
2 While the indicator is blinking, press [BD/DVD] to
change the setting.
≥ The setting changes each time [BD/DVD] is pressed.
≥ The setting will be reset to on when this system is
turned off.
With this function turned on, this unit can be set to
automatically switch to standby mode if there is no signal
input and no operation is performed for 2 hours.
1
Press and hold [INPUT SELECTOR] for more than 2
sec.
≥ The indicator for the current setting blinks for 10 sec.
2 While the indicator is blinking, press [INPUT
SELECTOR] to change the setting.
≥ The setting changes each time [INPUT SELECTOR]
is pressed.
≥ The setting is maintained until it is changed again.
∫ Remote control code
When other Panasonic devices respond to this system’s
remote control, change the remote control code on the
active subwoofer and the remote control.
(Continued on the next page)
Changing the dual audio
A : Main
B : Secondary
A, B : Main and secondary
Auto gain control
Dolby Digital indicator blinks:
Auto gain control is on.
PCM indicator blinks:
Auto gain control is off.
To turn off the 3D
surround effect and
clear-mode dialog effect
Dolby Digital indicator blinks:
3D surround effect and
clear-mode dialog effect are on.
PCM indicator blinks:
3D surround effect and
clear-mode dialog effect are off.
Auto standby function
Dolby Digital indicator blinks:
Auto standby function is on.
PCM indicator blinks:
Auto standby function is off.
Others
The following settings are unnecessary under
general usage conditions of the system.
SC-HTB20EBEGGNGS_VQT4E52.book 25 ページ ２０１２年２月２４日 金曜日 午後７時５１分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
