Operations
23
VQT4E52
As a factory preset, Dolby Virtual Speaker and
the 3D surround effects will be applied to Multi-
channel audio sources, such as those from a Blu-
ray Disc player or DVD player, etc.
By changing the audio output setting, it is
possible to apply the Dolby Virtual Speaker and
3D surround effects to 2ch audio sources, such
as the audio from the TV.
Press and hold [MUTE] for more
than 2 sec.
≥ The indicator for the current setting blinks for 10 sec.
While the indicator is blinking,
press [MUTE] again to change
the setting.
≥ The setting changes each time [MUTE] is pressed.
§1 Depending on the audio source, Dolby Virtual Speaker
and 3D surround effect settings are automatically
adjusted.
When using the optical digital audio cable, Dolby Virtual
Speaker and the 3D surround effect will be automatically
cancelled if the audio signal’s sampling frequency is greater
than 48 kHz.
Audio output modes
To change the audio
output mode
Audio output mode
Dolby Virtual
Speaker and 3D
surround effect
Multi-channel mode
The effects are
applied to all audio
sources.
Auto mode (Direct mode)
§1
(Factory preset)
The effects are
applied to Multi-
channel audio
sources.
The effects are not
applied to 2 channel
audio sources.
§2 This indicator will
also blink when
the audio source
is Multi-channel
audio.
2ch mode
The effects are not
applied to any
audio source.
SC-HTB20EBEGGNGS_VQT4E52.book 23 ページ ２０１２年２月２４日 金曜日 午後７時５１分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
