Others
104
VQT1P61
Auto focus
function does not
work.
≥ Is manual focus mode selected?
# Set the unit to auto focus mode by pressing the AUTO
button.
≥ Are you trying to record a scene which is hard to
bring into focus in auto focus mode?
# There are some recording subjects and surroundings
for which the auto focus does not operate correctly.
(l 113) If so, use the manual focus mode to adjust the
focus. (l 54)
Sound is not
played back from
the built-in speaker
of this unit.
≥ Is the volume too low?
# During playback, press the volume button to display
the volume indication and adjust it. (l 61)
Audio cannot be
output when
playing back
motion pictures on
an SD card
recorded with other
models or devices.
≥ If the Audio Recording setting on the other device is
set to [DOLBY], audio cannot be played back with this
unit.
During playback,
the sound from the
camera’s motor is
heard in the
recording.
≥ This is a mechanical sound of the camera, but it is not
a malfunction.
≥ Are there drops of water on the microphone?
# The recorded mechanical sound may become louder
and the microphone’s sensitivity may decrease when
there are drops of water on the microphone.
Wipe off any drops of water and then leave the unit to
dry naturally.
The speaker
volume during
playback is low.
≥ Are there drops of water on the microphone?
# The volume of the output sound may decrease when
the speaker is wet.
After wiping off any drops of water and then leaving the
unit to dry naturally, it will return to normal.
Problem Check points
SDR-S9-VQT1P61_eng.book 104 ページ ２００７年１２月１８日 火曜日 午後３時５９分
To Next Page
Loading...
