Panasonic TH-42PV60H

11.5. Sub-Contrast adjustment
Name of measuring instrument Connection Remarks
RF generator
Base Band generator
Preparation (AV) Remarks
1. Receive AV1 (PAL 100% Full White or Split Colour bar shown as below) .
2. Goes into service mode, choose Sub-Contrast, and it checks that data value is 512.
(It checks that an initial value is a default)
Adjustment of AV system Remarks
1. The colour key yellow button of remote control is pushed.
2. The OSD character of sub-contrast becomes red.
(Inside under automatic adjustment)
3. The OSD character of sub-contrast returns to white.
4. End.
Preparation (RF) Remarks
1. Receive RF (PAL 100% Full White or Split Colour bar shown as below.)
2. Goes into service mode, choose Sub-Contrast, and it checks that data value is 512.
(It checks that an initial value is a default)
Adjustment of RF system Remarks
1. The colour key yellow button of remote control is pushed.
2. The OSD character of sub-contrast becomes red.
(Inside under automatic adjustment)
3. The OSD character of sub-contrast returns to white.
4. End.
Preparation (HD) Remarks
1. Receive Component
(1080i/ 60Hz or 1080i/ 50Hz, 100% Full White or Split colour bar as shown below.)
2. Goes into service mode, choose Sub-Contrast, and it checks that data value is 384.
(It checks that an initial value is a default)
Adjustment of HD system Remarks
1. The colour key yellow button of remote control is pushed.
2. The OSD character of sub-contrast becomes red.
(Inside under automatic adjustment)
3. The OSD character of sub-contrast returns to white.
4. End.
39
TH-42PV60A / TH-42PV60H / TH-42PV60M / TH-42PV60MT