28
Tuning Menu
Auto Tune
This television has been factory tuned to all major city channels. Use the automatic tuning procedure only if you wish
to reset ALL Programme Location Numbers. Refer to “Manual Tune” on page 30 if you only want to retune one or
two Programme Location Numbers.
The television should be switched ON and the TV/AV Switch set to TV.
When you start the automatic search, the television will automatically search for television broadcasts through both
VHF bands and the UHF band. During this process all of the available television broadcast channels will be auto-
matically allocated to sequential Programme Number locations depending on the mode selected (See page 28).
Using the Front Panel Using the Remote Control
1. Push the button repeatedly until the Tuning
Menu is reached. (See page 26).
2. Push the or Button to access the Tuning
Menu.
3. Push the button to access Auto Tune.
4. Push the or Button to start the search.
1. Push the Set Up ( ) button.
2. Push the or button to select the
Tuning Menu. (See page 26).
3. Push the or button to access the Tuning
Menu.
4. Push the or button to select the Auto
Tune.
5. Push the or button to start the Auto Tune.
Push the Set Up ( ) button to return the television to
the Tuning menu.
Push the button to return the television to the
Tuning Menu.
F : RETURN TO TUNING MENU
TV/AV : TO EXIT
AUTO SETUP IN PROGRESS
SEARCHING :
STORED CH29
29
CH 29
Push the button to return the television to normal operation.
STR F -/\/ +//\ TV/AV
TUNING MODE
F : NO - , + : YES
The television will automatically allocate each received broadcast signal to a Programme Number
depending on the mode selected (See page 28). As each station is stored the Panasonic logo will
appear momentarily. The operation will cease when all available channels have been tuned.
SETUP : RETURN TO TUNING MENU
TV/AV : TO EXIT
AUTO SETUP IN PROGRESS
SEARCHING :
STORED CH29
29
CH 29
To Next Page
Loading...
