Panasonic WJ-ND400K

33
■ Auto adjustment time
Select a method of auto clock adjustment from the fol-
lowing.
Off (default): Does not adjust clock automatically.
Slave: Receives a signal from the master unit and
adjusts the clock of the recorder.
Master: Supplies a signal from the ALARM/CONTROL
connector on the rear panel to the connected devic-
es and the devices will adjust their clocks with refer-
ence to the clock of the recorder.
■ Activation time
Set the time to start the auto clock adjustment.
When "Master" is selected for "Auto adjustment time",
set the time for a signal to supply from the ALARM/
CONTROL connector (time adjustment I/O, pin no. 20)
at the rear of the recorder.
When "Slave" is selected, set the time for the recorder
to receive a signal from the master unit and adjust the
clock.
■ Summer time(daylight saving)
Determine how to shift to/from the summer time from
the following. During summer time, the time will be dis-
played with an asterisk (*).
Out (default): Summer time will not be applied.
Auto: Applies summer time in accordance with the set-
ting of summer time.
■ Summer time(daylight saving) table
Set the start (In)/end (Out) time and date of summer
time.
When the [Setup >>] button is clicked, the following
window will be displayed.
Set the start time and date and the end time and date
of summer time. Select the last 2 digits of the year.
Up to 10 settings can be set.
Click the [Set] button after completing the settings, and
close the window by clicking the [X] button at the top
right of the window.
Important:
 • Ablackscreenmaybedisplayedandrecordingmay
not be performed for around 4 seconds just after
configuring/editing the following settings.
 • Whenthecurrenttimeanddatesettingiscon-
figured/edited
 • Whenthesummertimeisappliedtothecurrent
time
 • When"Slave"isselectedfor"Autoadjustment
time" and the clock of the recorder is adjusted
(However, when an emergency recording or an
event recording is being performed, the clock
will not be adjusted.)