Panasonic WJ-ND400K

68
1 Click the [Network] button.
2 Click the [SNMP] tab.
The "SNMP" page will be displayed.
3 Configure each setting item.
Refer to "Setup items" mentioned below.
4 Click the [Set] button.
SNMP
Configure the settings to use the SNMP (Simple Network Management Protocol). Configure the settings to check
the status of the recorder, etc. by connecting the SNMP manager.
■ Community
Enter a name used for SNMP community in alphanu-
meric characters.
Enter up to 32 alphanumeric characters. The available
characters are the characters listed below.
ABCDEFGHIJKLMNOPQRSTUVWXYZ
a b c d e f g h i j k l m n o p q r s t u v w x y z 0 1 2 3 4
5 6 7 8 9 ! # $ % ' ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _ { | } ~
■ System name
Enter a system name in alphanumeric characters to
manage the recorder by the SNMP system, for exam-
ple, No1.
Enter up to 255 alphanumeric characters.
■ Location
Enter a location name (location where the recorder is
installed) in alphanumeric characters, for example, 2F.
Enter up to 255 alphanumeric characters.
■ Contact
Enter the contact information (mail address, etc.) of the
administrator of the recorder.
Enter up to 255 alphanumeric characters.
Setup items