Panasonic WJ-ND400K

69
1 Click the [Network] button.
2 Click the [Panasonic alarm protocol] tab.
The "Panasonic alarm protocol" page will be dis-
played.
3 Configure each setting item.
Refer to "Setup items" mentioned below.
4 Click the [Set] button.
Panasonic alarm protocol
Configure the setting to notify of an event occurrence (or error information) to PCs (addresses) registered in
advance.
Up to 4 destination addresses can be registered.
To receive a notification of an event occurrence (or error information) and display the contents of the notification,
the dedicated software* is necessary.
* Refer to the "readme.txt" on the provided CD-ROM about the dedicated software.
■ Port number(to PC)
Enter the port number to be used for the Panasonic
alarm protocol.
Default: 1818
■ Retry
Set the number of retry attempts for the transmission to
the PC.
1 - 30 (Default: 2)
Destination address
■ Address1 - Address4
Enter the addresses of the destinated PCs. Enter the IP
address or host name for "Address1" - "Address4".
Enter up to 255 alphanumeric characters including
hyphens (-), periods (.) and underscore (_).
Note:
 • Toenterahostname,itisnecessarytoselect
"Manual" or "Auto" for "DNS".
Setup items