Panasonic WJ-ND400K

15
About the operation window
Display/Close the operation window
Display the operation window using a web browser installed on a PC.
1 Boot the PC.
2 Launch a web browser.
3 After the browser starts, enter the IP address set
to the recorder in the address box, and press the
enter key.
The authentication window will be displayed.
This window will not be displayed when "Off" is
selected for "User authentication" on the "Basic"
tab page of "User management". (Page 70)
Important:
 • RefertoasystemadministratorforthesetIP
address of the recorder.
 • ItisimpossibletoaccesstherecorderfromaPC
which IP address is not registered to the recorder
when "On" is selected for "Host authentication" on
the "Basic" tab page of "User management". (Page
70)
Refer to a system administrator for further informa-
tion.
 • Donotattach"0"beforethenumberswhenentering
IP address.
Example:
OK: 192.168.0.50
NG: 192.168.0.050
 • Ifamessageisdisplayedontheinformationbar,
see page 102.
4 Enter the user name and password registered on
the recorder and then click the [login] button.
The top page will be displayed.
Important:
 • Refertoasystemadministratorforthesetuser
name and password.
Refer to the "User" section on page 72 for informa-
tion on how to register users.
 • Thedefaultadministratornameandpasswordare
as follows
User name: ADMIN
Password: 12345
 • Toenhancethesecurity,changethepasswordfor
an administrator before running the recorder.
Change the password periodically. Refer to page 72
for information on how to change the password.
 • Whentherecorderisbeingoperatedwithoutchang-
ing the user name and password, the pop-up win-
dow saying that it is recommended to change the
password will be displayed.