Panasonic WJ-ND400K - Page 66

66
Static route
■ Static route setting
Select "On" or "Off" (default) to determine whether or
not to validate the static route setting.
Configure this setting after considering the network
connection environment of this product.
■ Address
Enter the destination address.
The following values are unavailable.
Broadcast address, loop-back address, class D
address, class E address, "0.0.0.0", "255.255.255.255",
and any of the address used for the camera port/client
PC port/maintenance port.
■ Subnet mask
Enter the subnet mask of the destination.
The following values are unavailable.
Broadcast address, loop-back address, class D
address, class E address, "0.0.0.0", "255.255.255.255",
and any of the address used for the camera port/client
PC port/maintenance port.
■ Gateway
Enter the gateway of the destination.
The following values are unavailable.
Broadcast address, loop-back address, class D
address, class E address, "0.0.0.0", "255.255.255.255",
any of the address used for the camera port/client PC
port/maintenance port, and any of other addresses
which are included in another subnet from the subnet of
camera port/client PC port/maintenance port.